xStack
®
DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide
241
Next Hop Self
Enable or disable the next hop self attribute. By default, this setting is Disabled
Soft Reconfiguration
Inbound
Enable or disable the inbound soft reconfiguration function. By default, this setting is
Disabled.
Remove Private AS
If this setting is set to Enabled, the private AS number in the AS path attribute of the
BGP update packets will be dropped. By default, the setting is Disabled.
Allow AS in
If this is Enabled, the BGP router’s self AS is allowed in the AS path list. By default,
this setting is Disabled. If no number is supplied, the default value of three times is
used.
Allow AS in Value (1-
10)
Enter an Allow AS in Value between 1 and 10.
Default Originate State
Enable or disable the default originate function. By default, this setting is Disabled.
Route Map Name
Enter a Route Map Name of a maximum of 16 characters.
Click the
Apply
button to accept the changes made.
BGP Neighbor Timer Settings
This window is used to configure BGP neighbor timer settings.
To view the following window, click
L3 Features > BGP > BGP Neighbor > BGP Neighbor Timer Settings
, as
shown below:
Figure 5-11831 BGP Neighbor Timer Settings window
The fields that can be configured are described below:
Parameter
Description
IP Address
Click the radio button and use the drop-down menu to select the IP address of the
BGP speaking neighbor.
Peer Group Name
Click the radio button and use the drop-down menu to select the name of the BGP
peer group.
Advertisement Interval
(0-600)
Enter the interval at which the BGP process sends update messages to its peer. The
valid value is from 0 to 600. If this value is set to zero, the update or withdrawn
message will be sent immediately. The default value for IBGP peers is 5 seconds and
for EBGP peers it is 30 seconds. When the
Default
check box is ticked, the neighbor
specific advertisement interval setting will be returned to the default setting.
Keepalive (0-65535)
Enter the interval at which a keepalive message is sent to its peers. If the two routers,
that build a BGP connection, have different keepalive timers, the smaller keepalive
timer will be unset. The valid value is from 0 to 65535. If the keepalive is set to zero,
then the keepalive message will not be sent out. Tick the
Default
check box to clear
the specification of the neighbor specific keepalive setting.
Summary of Contents for xStack DGS-3620-52P
Page 1: ......
