D-Link xStack DGS-3400 Series, User Manual, Page: 182 / 326

xStack DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch
Destination IPv6
Address The user may specify an IP address mask for the destination IPv6 address by and entering the
IP address mask, in hex form.
Port The Access Rule may be configured on a per-port basis by entering the port number of the
switch in the switch stack into this field. When a range of ports is to be configured, the
Auto
Assign check box MUST be clicked in the Access ID field of this window. If not, the user will be
presented with an error message and the access rule will not be configured. The port list is
specified by listing the lowest switch number and the beginning port number on that switch,
separated by a colon. Then the highest switch number, and the highest port number of the range
(also separated by a colon) are specified. The beginning and end of the port list range are
separated by a dash. For example, 1:3 specifies switch number 1, port 3. 2:4 specifies switch
number 2, port 4. 1:3 - 2:4 specifies all of the ports between switch 1, port 3 and switch 2, port 4
−
in numerical order. Entering all will denote all ports on the Switch.
Rx Rate
Use this to limit Rx bandwidth for the profile being configured. This rate is implemented using the
following equation: 1 value = 64kbit/sec. (ex. If the user selects an Rx rate of 10 then the ingress
rate is 640kbit/sec.) The user many select a value between 1- 156249 or
No Limit . The default
setting is No Limit.
Time Range
Click the check box and enter the name of the Time Range settings that has been previously
configured in the
Time Range window. This will set specific times when this access rule will be
implemented on the Switch.
To view the settings of a previously correctly configured rule, click in the Access Rule Table to view the following screen:
Figure 8- 17. Access Rule Display (IPv6)
168