D-Link WMP-G04, Manual

Page: 33 / 33

This device is intended only for OEM integrators under the following conditions:
(1) The antenna must be installed such that 20cm is maintained between the antenna and users, and
(2) The transmitter module may not be co-located with any other transmitter or antenna.
As long as the 2 conditions above are met, further transmitter testing will not be required. However, the
OEM integrator is still responsible for testing their end-product for any additional compliance
requirements required with this module installed (for example, digital device emission, PC peripheral
requirements, etc.).
IMPORTANT NOTE:
In the event that these conditions can not be met (for example certain laptop configurations or co-location
with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID can
not be used on the final product. In these circumstances, the OEM integrator will be responsible for
re-evaluating the end product (including the transmitter) and Obtaining a separate FCC authorization.
End Product Labelling:
This transmitter module is authorized only for use in devices where the antenna may be installed such that
20cm may be maintained between the antenna and users (for example access points, routers, wireless
ADSL modems, and similar equipment). The final end product must be labeled in a visible area with the
following: “ Contains TX FCC ID:
RRK20031200281
“.
Manual Information That Must be Included:
The users manual for end users must include the following information in a prominent location ”
IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the antenna used for
this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and
must not be co-located or operating in conjunction with any other antenna or transmitter.”
3
3