D-Link WMP-G04 Manual Download

Page: 32 / 33

Governing Law:

This Limited Warranty shall be governed by laws of the State of California. Some states

do not allow exclusion or limitation of incidental or consequential damages, or limitations on how long an
implied warranty lasts, so the foregoing limitations and exclusions may not apply. This Limited warranty
provides specific legal rights and the product owner may also have other rights which vary from state to
state.

Trademarks:

D-Link is a registered trademark of D-Link Systems, Inc. Other trademarks or registered

trademarks are the Property of their respective manufacturers or owners.

Copyright Statement:

No part of this publication or documentation accompanying this product may be

reproduced in any form or by any means or used to make any derivative such as translation,
transformation, or adaptation without permission from D-Link Corporation/D-Link Systems, Inc., as
stipulated by the United States Copyright Act of 1976. Contents are subject to change without prior notice.
Copyright 2002 by D-Link Corporation/D-Link Systems, Inc. All rights reserved.

Federal Communication Commission Interference Statement:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one of the following measures:

■

Reorient or relocate the receiving antenna.

■

Increase the separation between the equipment and receiver.

■

Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.

■

Consult the dealer or an experienced radio/TV technician for help.

FCC Caution:

To assure continued compliance, (example – use only shielded interface cables when

connecting to computer or peripheral devices) any changes or modifications not expressly approved by
the party responsible for compliance could void the user’s authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.

Statement Needed to be Shown on End Product:

Since this module is installed inside the end product, the end product should be affixed a label on visible
area showing that this product contain a RF module, and also its FCC ID.

IMPORTANT NOTE:
FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance of about eight inches (20cm)
between the radiator and your body.

This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.