87
Using IP surveillance Software (continued)
Modulation Mode
You must select the input signal format (NTSC or PAL) for
displaying the original resolution of video stream from
DCS-5300G
.
NOTE: You need to select the input signal format according to the camera
type or CCD module type that is connected to the
DCS-5300G
. Due to the
nature of CMOS sensors (for the
DCS-2000
and
DCS-2100+
), the input signal
format needs to be set to PAL regardless whether the power line frequency
connected is 50 or 60Hz.
Display Options:
In the video displaying frame of each channel, there are two status bars. The
upper bar contains “Camera location” and “time of the remote site.” The lower
bar contains “Connection time” and “Recording time.” All of them, shown in the
figure below, can be enabled or disabled here individually for the status indication.
Apply to full screen mode can also be turned on here. Once it has been checked,
the status bar in each channel showing date, location, connection, and recording
time will be shown in both display frame mode and full screen mode.
0 day 00:01
Location (channel Text on Video)
Remote Time
Connection Time (Day:Hour:Min)
Recording Time (Day:Hour:Min)
Monitor Program (continued)
Summary of Contents for SECURICAM Network DCS-5300G
Page 141: ...141 Time Zone Table continued ...
