128
There is a button hidden in the pinhole beside the Ethernet socket. It is
used to
reset
the system or
restore
the factory default settings.
Sometimes resetting the
DCS-2100+
will return the system back to a
normal state. If the system still has problems after reset, restore the
factory settings and install again:
RESET
:
1. Lightly insert a paper clip (or a similar sized tool) into the
reset hole on the back of the camera, press lightly and
then release the button.
2. The LED on the front of the camera will begin blinking red
and green fast.
3. When the LED stops the blinking fast and starts blinking
once every second, the reset is completed.
RESTORE
: 1. Insert the paper clip, or another similar tool, and press
and continuously hold down the button recessed inside
the reset hole.
2. Wait for the LED on the front of the camera to blink red
and green and hold the button through two cycles of
blinking (about 5-7 seconds.)
3. Withdraw the tool after the second cycle of the LED
blinking and a factory restore has been completed.
Reset and Restore
Reset button
Restoring the factory defaults will result in the
loss of any previous settings and will require
running the
Installation Wizard
to find the
camera’s IP address.
Summary of Contents for SECURICAM Network DCS-2100+
Page 139: ...139 Time Zone Table continued ...
