136 © 2001-2008 D-Link Corporation. All Rights Reserved.
D-Link Unified Access Point Administrator’s Guide
Ethernet Settings
Use the commands in this section to view and set values for the Ethernet (wired) interface.
NOTE: Before configuring this feature, make sure you are familiar with the names of
the interfaces as described in
“Interface Naming Conventions”
on page 132.
The interface name you reference in a command determines whether a setting
applies to a wired or wireless interface, the Internal network, or to radio
“one” or radio “two”.
Get neighboring access points
get detected-ap detail
Get information about switches that
can discover and manage the AP
get managed-ap
Table 36.
Ethernet Setting Commands
Action
Command
Get Summary View of Internal
Interfaces
get bss
Get the DNS Name
get host id
Set the DNS Name
set host id
<
host_name>
For example:
set host id vicky-ap
Get Current Settings for the
Ethernet (Wired) Internal Interface
get management
Set the management VLAN ID
set management vlan-id
<1-4094>
View untagged VLAN information
get untagged-vlan
Enable the untagged VLAN
set untagged-vlan status up
Disable the untagged VLAN
set untagged-vlan status down
Set the untagged VLAN ID
set untagged-vlan vlan-id
<1-4094>
View the connection type
get management dhcp-status
Use DHCP as the connection type
set management dhcp-client status up
Use a Static IP as the connection
type
set management dhcp-client status down
Set the Static IP address
set management static-ip
<ip_address>
Example:
set management static-ip 10.10.12.221
Set a Subnet Mask
set management static-mask
<netmask>
Example:
set management static-mask 255.0.0.0
Set the Default
Gateway
set static-ip-route gateway
<ip_address>
Example:
set static-ip-route gateway 10.10.12.1
Table 35.
Status Commands
Action
Command
