52
DSL-504T User’s Manual
D-Link Systems, Inc.
Configuring the WAN Connection
PPPoE and PPPoA Connection for WAN (continued)
If you have not been instructed to change the ATM settings at the
bottom of the menu, leave these at the default settings. If you have
been given new settings to configure, select the Service Category
and type in the values for PCR and VCI in Kbps.
ATM:
Apply:
Click Apply when you have completed the configuration.
Click to select the PPPoE/PPPoA radio button in the WAN Settings
options list. This is selected by default if you are configuring the Router
for the first time. If it is not selected, click the PPPoE/PPPoA radio
button located under the WAN Settings heading
WAN Settings:
Under the PPPoE/PPPoA heading, type the User Name and
Password used for your ADSL account. A typical User Name will
be in the form [email protected], the Password may be assigned to
you by your ISP or you may have selected it when you set up the
account with your ISP.
PPPoE/PPPoA:
User Name
&
Password
Set NAT to Enabled unless you have been told that NAT must be
Disabled for your account.
NAT
PPPoE/PPPoA:
Default Route
If you are instructed to use enable Default Route, this setting
specifies that the Router be used to define the default route to the
Internet for your LAN. Whenever a computer on the LAN attempts to
access the Internet, the Router becomes the Internet gateway to the
computer.
PPPoE/PPPoA:
Leave the MTU/MRU value at the default setting (default = 1492)
unless you have been instructed to change this.
PPPoE/PPPoA:
MTU/MRU
Choose the Connection Type from the pull-down menu located
under the User Name and Password entry fields. This defines both
the connection protocol and encapsulation method used for your
ADSL service. The available options are PPPoA VC-MUX, PPPoA
LLC and PPPoE LLC. If you have not been provided specific
information for the Connection Type setting, leave the default setting.
PPPoE/PPPoA:
Connection Type
Check with your ISP.
AC Name:
Check with your ISP.
Service Name:
The new settings must be saved and the Router must be restarted for the settings to go into
effect. To Save & Reboot the Router, click on the Tools directory tab and then click the Misc
menu button. In the Misc Settings menu, click the Reboot button under Force the DSL-504T to
system restart. The Router will save the new settings and restart. Upon restarting the Router
will automatically establish the WAN connection
Summary of Contents for DSL-504T
Page 1: ......