D-Link DSL-360T, User Manual

Page: 8 / 67

DSL-360T DSL Modem User’s Guide
viii
Information Required for Installation
Information you will need from your ADSL service provider:
Username
This is the Username used to log on to your ADSL
service provider’s network. It is commonly in the form
−
user@isp.com. Your ADSL service provider uses this
to identify your account.
Record info here
Password
This is the Password used, in conjunction with the
Username above, to log on to your ADSL service
provider’s network. This is used to verify the identity of
your account.
Connection Protocol
This is the method your ADSL service provider uses to
send and receive data between the Internet and your
computer. Your Modem supports the following
connection protocols: PPPoE, PPPoA, CLIP (IPoA) and
Bridge.
Security Protocol
This is the method your ADSL service provider will use
to verify your Username and Password when you log
on to their network. Your Modem supports the PAP and
CHAP protocols.
VPI
This is the Virtual Path Identifier (VPI). It is used in
conjunction with the Virtual Channel Identifier (VCI)
below, to identify the data path between your ADSL
service provider’s network and your computer.
VCI
This is the Virtual Channel Identifier (VCI). It is used in
conjunction with the VPI above to identify the data path
between your ADSL service provider’s network and
your computer.
Information you will need to change settings on the DSL-360T Modem:
Username
This is the Username needed access the Modem’s
management interface. When you attempt to connect to
the device through a web browser you will be prompted
to enter this Username. The default Username for the
Modem is
admin . This may be changed by the user.
Record info here
Password
This is the Password you will be prompted to enter
when you access the Modem’s management interface.
The default Password is
admin . This may be changed
by the user.
LAN IP addresses for
the DSL-360T
This is the IP address you will enter into the Address
field of your web browser to access the Modem’s
configuration graphical user interface (GUI) using a
web browser. The default IP address is 192.168.1.1
and it is referred to as the “Management IP” address in
this User’s Manual. This may be changed to suit any IP
address scheme the user desires. This address will be
the base IP address used for DHCP service on the LAN
when DHCP is enabled.
LAN Subnet Mask for
the DSL-360T
This is the subnet mask used by the DSL-360T, and
will be used throughout your LAN. The default subnet
mask is
255.255.255.0 . This can be changed later.