DHCP, DNS and Time
Dlink DRO-220i User Guide
22
If you have purchased multiple static Global IP Addresses from the ISP, then configure
the first IP Address as the WAN Interface IP Address. And use the rest of your static IP
Addresses for Many-To-Many or One-To-One NAT Configuration.
Select
Interface
→
WAN3
and choose
IP Setting Mode
as
Static
.
Configure
IP
Settings for WAN3 Interface
as explained below.
IP Settings for WAN3 Interface
IP Address
Enter the IP address assigned for the WAN interface
Subnet Mask
Enter the subnet mask for the IP address
Default Gateway
Enter the default gateway address (in the same subnet).
MTU
Enter the MTU value for the WAN. Default value is 1500.
Click on
Detect Link Status
to configure the
Ethernet WAN Link Detection
Feature.
L
Note:
The default gateway field specified here will be used by Load balancing feature
to route packets through this interface.
2.5.2 Dynamic Mode
In this mode, ISP provides the Global IP address automatically using DHCP Protocol. A
DHCP Client is built into router to support this mode of connectivity.
Select
Interface
→
WAN3
and choose
IP Setting Mode
as
Dynamic
.
Configure
DHCP
Settings for WAN3 Interface
as explained below.
DHCP Settings for WAN3 Interface
Host Name
(optional)
Enter the hostname assigned for the WAN interface
MAC Address
Displays the MAC address of the router’s WAN Port.
MTU
Enter the MTU value for the WAN. Default value is 1500.
After entering all the information press the
Apply
button. The
DHCP Client Status
table
will now show the DHCP client status at the bottom of the page.
Click on
Detect Link Status
to configure the
Ethernet WAN Link Detection
Feature.
Web UI
Web UI
