18
L2TP Retype Password
Retype the password that was entered in the L2TP field. Ensure that
these two passwords are identical or an error will occur.
Maximum Idle Time
A value of 0 means the PPP connection will remain connected. If your
network account is billed according to the amount of time the Router
is actually connected to the Internet, enter an appropriate Idle Time
value (in seconds). This will disconnect the Router after the WAN
connection has been idle for the amount of time specified. The default
value = 5.
MTU
Enter an MTU value only if required by your ISP. Otherwise, leave it at
the default setting.
Connect Mode
If Connect-on-demand is selected, will allow the router to connect any
workstation on your LAN to the Internet upon request. If Always-on, no
request from the workstation will be needed to connect to the Internet.
If Manual is selected, the workstation on the LAN must manually
connect to the Internet through this router.
HOME > WAN > Other>BigPond Cable
This selection is for users having Big Pond Cable as their ISP. Enter the following information, as
provided to you by your ISP.
User Name
Enter the user name as provided to you by your ISP.
Password
Enter The PPPoE user name provided to you by your ISP.
Retype Password
Retype the password entered in the previous field.
Auth Server
Enter the name of the Authentication Server as provided to you by your
ISP. This is the computer that will accept your user name and password
to be authenticated on the network.
Auto Reconnect
Checking the
Enabled
radio button will allow the router to reconnect to
the network automatically if it becomes disconnected.
MAC Address
The default MAC Address is set to the WAN’s physical interface MAC
address on the Broadband Router. It is not recommended that you
change the default MAC address unless required by your ISP.
Clone MAC Address
The default MAC address is set to the WAN’s physical interface MAC
address on the Broadband Router. You can use the
Clone MAC
