D-Link DG-102SH, User Manual

Page: 13 / 79

DG-102SH VoIP Station Gateway
7
Once you have set an IP address for your device, you can use a Telnet program (in a VT-100 compatible
terminal mode) to access and configure it. Most of the screens are identical, whether accessed from the console
port or from a Telnet interface.
The console interface makes use of the following conventions:
Items in
<
angle brackets
>
can be toggled on or off using the space bar.
Items in
[
square brackets
]
can be changed by typing in a new value. You can use the Backspace and Delete
keys to erase characters behind and in front of the cursor.
The up and down arrow keys, the left and right arrow keys, the Tab key and the Backspace key can be used to
move between selected items. It is recommended that you use the Tab key and Backspace key for moving
around the console.
Items in UPPERCASE are commands. Moving the selection to a command and pressing Enter will execute
that command, e.g. APPLY, etc.
Please note that the command
APPLY
only applies for the current session. Use Save Changes from the
Main Menu for permanent changes.
First make the console connection to the device and then power it on. If your terminal (or terminal emulation
program) is properly configured according to the specifications defined above, you will see the POST test and
the boot up process. During this process, press <Ctrl+C> to reach the Boot Menu (shown below).