Trouble shooting
Problem
Possible cause
Remedy
Fault indication (LED flashes yellow)
Overcurrent cutoff has released,
Fitting be serviced by specialist company
because window fitting is too sluggish
Overcurrent cutoff, because final positions Take off drive housing and
are wrong after emergeny unlocking
move fitting in correct position
FRA 11-BSY+ no function (LED off)
No power supply
Check power supply
Window drive runs open,
DIP-switch S1.1 is wrongly set
Change DIP-switch S1.1
although FRA 11 BSY+ locks
FRA 11-BSY+ runs open up to 90°
DIP-switch S1.2 is wrongly set
Set DIP-switch S1.2 to 180° window
turning position only and drive runs open
LED flashes yellow after unlocking
DIP-switch S1.2 is wrongly set
Set DIP-switch S1.2 to 90° window
(90° / 180° window)
Drive does not run closed,
DIP-switch S2 is wrongly set
Set DIP-switch S2 to correct
but FRA 11-BSY+ locks
CLOSED-signal modification
FRA 11-BSY+ does not lock
CLOSED-signal not connected
Connect CLOSED-signal
DIP-switch S2 is wrongly set
Set DIP-switch S2 to correct
CLOSED-signal modification
Error notification while BSY+ operation
Wrong adress allocation,
Adress reallocation with SW-BSY+
window drive signals error
resp. fault analysis
9/16
English
Maintenance and cleaning
Inspection and maintenance has to be carried out
according to D+H maintenance notes. Only original
D+H spare parts may be used. Repair is to be carried
out exclusively by D+H.
Wipe away debris or contamination with a dry, soft
cloth.
Do not use cleaning agents or solvents.
Declaration of Conformity
Electrical devices, accessories and packaging
should be sorted for environmental-friendly recycling.
Only for EC countries:
Do not dispose electrical
devices into household waste!
According the European Guideline
2002/96/EC for waste electrical and
electronic equipment and its implemen-
tation into national right, electrcal devices that are no
longer usable must be collected separately and
disposed of in an environmentally correct manner.
Disposal
Guarantee
You will get
for all D+H products
from date of verified handing over of the system up to
maximal 3 years after date of delivery, when
mounting and starting has been carried out by
D+H guarantee is expired, with connection of D+H
components with external systems or with mixing of
D+H products with parts of other manufacturers.
2 years guarantee
an
authorized D+H-distributor.
We declare under our sole responsibility that the
product described under “Technical Data” is in
conformity with the following directives:
2004/108/EC, 2006/95/EC
Technical file at:
D+H Mechatronic AG, D-22949 Ammersbek
Thomas Kern
Maik Schmees
Member of the Board
Authorized signatory, Technical Director
12.10.2009
FRA 11-BSY+
99.823.20 2.2/10/12