D+H BDT 010-EO, Original Instructions Manual

Page: 24 / 32

BDT-010-EO BDT-010-EO 99.827.67 1.0/08/18 99.827.67 1.0/08/18
24/32 25/32
English English
Control elements
Position indicator (page 25)
Symbolizes the position of the fitting.
LED radio display
Every operation of the optional remote control will be
acknowledged by a flashing of the radio display.
CLOSE
Briefly push to close the window.
OPEN to the parallel opening position
Briefly push to move the window to the parallel opening
position.
OPEN to the turning position
Push for 1 s and the drive moves the window to
the turning position for normal, manual opening.
Timer-controlled ventilation
Briefly push once to move the drive to the parallel opening
position. After a ventilation time of 10 minutes, it moves
back to the closed position. Pushing the key again extends
the ventilation time by 10 minutes each time:
Pushed once: ventilate for 10 min.
Pushed twice: ventilate for 20 min.
Pushed three times: ventilate for 30 min.
Automatic/interval ventilation
Briefly pushing the automatic key activates automatic or
interval ventilation. If this is activated, the room will ventilated
in the parallel opening position for 10 minutes every hour.
Info
Briefly pushing the key will light up the symbols and display
the current modes for 20 s when darkened.
Programming key (page 26 and 27)
Position indicator
The position indication at the pushbutton of the drive symbolizes the position of the fitting.
The position of the marking is comparable with the position of a normal window handle.
Closed an
locked Parallel position
hinge on the right
Turning position Parallel position
hinge on the left
Electrical devices, accessories, batteries and packa-
ging should be sorted for environmental-friendly
recycling. Do not dispose electrical devices and
batteries into household waste!
Only for EC countries:
According the European Guideline 2012/19/EU for
waste electrical and electronic equipment and its
implementation into national right, electrcal devices
that are no longer usable must be collected separa-
tely and disposed of in an environmentally correct
manner.
Disposal
Type BDT-010-EO
Power supply 24 V DC ± 15 %
Ripple < 10 %
Rated current 1 A
Standby current app. 15 mA
Torque 10 Nm
Turning angle 90° or 180°
Running time app. 8 Sec. / 180°
Lifetime > 40.000 Cycles
Duty cycle 30 % (cycle time10min.)
Housing Zinc die casting, ABS, polycarbonate
Ingress protection IP 40
Temp. range -5°C ... +60°C
EnOcean® radio module TCM 310
Frequency 868,3 MHz according to RED-specification
Max. radiated power + 1,4 dBm
Modulation type ASK
Antenna internal
Transmission range up to 30 m inside building (depending on building stock)
EnOcean triggering F6-02-01 Rocker Switch
EnOcean position feedback F6-10-00 Mechanical Handle
Connection 6 pole screw terminal
Technical Data
Maintenance and cleaning
- Maintenance work is only allowed when the device is
in a de-energized condition!
- The drive is maintenance-free.
- Regular visual inspection of all system components
and cable connections for outer damage and dirt
accumulation.
- Only original D+H spare parts may be used.
- Repair is to be carried out exclusively by D+H.
- Wipe away debris or contamination with a dry, soft
cloth.
- Do not use cleaning agents or solvents.