4
Changing the Blade
Use provided Allan wrench to remove the
five screws as shown, then hold the blade
by each end and carefully remove the
blade out of the blade holder.
Note:
when putting a new blade on, keep
the flat side of the blade facing the main
table.
Warning:
Do not put your fingers against
the sharp edge of the blade at any time.
Bevel Cut (2)
Place the work-piece flush with either side
of the guide bar on the working table and
align the blade to the mark on the
work-piece where needs to be cut. Then
press the handle down to complete the
cut.
Bevel Cut (3)
Place the work-piece flush with either
side of the guide bar on the working
table and make a cut to get a half inside
corner and a half outside corner Then
turn the work-piece around and place it
flush with other side of the guide bar,
then make the second cut to get
another half inside corner and another
half outside corner.
Note:
Keep the flat part of the work-pie
ce down towards the working table.
