4
Lengthwise Cut
Insert the floor plank between the
cutting blade and the working table
along with the guiding bar which
can be locked on both sides of the
working table. Keep moving the
plank along with the guide bar after
each cut until the whole plank is
completely cut.
Notch Cut
Make a lengthwise cut first to the
desired length on the floor plank as
mentioned above, then turn the
plank at 90°, and put desired cutting
point right under the blade.
Unlock two screws on both side of
the blade holder as shown and pull
out the blade holder out to above
mentioned desired cutting point,
then press the handle down to
complete a cut.
45° Cut
Position the guide bar at 45°. Insert the
floor plank between the cutting blade
and the base, along with the guide bar
as shown, and then press the handle
down to complete a cut.
