3
CUTTING AND C
Installation of the Cutter (1)
Install the Cam assembly to the cutter
base with provided nuts and rotating
shaft as shown.
After the cam bar is installed properly,
remove the red nylon stopper so the
cutter is ready for the cutting job.
Straight Cut
Insert the floor plank between the
cutting blade and the base, flush with
the guide bar on the working table and
hold the plank, and then press the
handle down to complete a cut.
Warning:
Maintain control of the
handle. Do not allow handle to slam
back after making a cut.
Installation of the Cutter (2)
Install the extended working table to
the cutter base with provided screws as
shown.
Install the handle assembly to the cutter
base with provided screws as shown.
Warning:
Do not put your fingers
against the sharp edge of the blade at
any time.
