MB2100-01A-E Single Port Embedded Emulator Debugger SPEED-BOX Operation Guide, Doc. # 002-05542 Rev. *A
3
Preface
SPEED-BOX *1 (MB2100-01A-E) is a development support tool for development and evaluation of
application products that use a microcontroller that supports JPwire *2.
JPwire is a standard of the single wire debugger designed by General Incorporated Association
JASPAR. SPEED-BOX complies with JPwire requirements.
This document describes the product handling and connection of this product for engineers who are
developing application products for the Cypress microcontrollers*3 using SPEED-BOX.
SPEED-BOX is a trademark of Cypress Semiconductor Corp.
JPwire is a registered trademark of General Incorporated Association JASPAR.
Referred to as the “MCU”
■
Using the product safely
This manual contains important information for using this product safely. Be sure to read this manual
before using the product, and to follow the directions given in this manual in order to use the product
correctly.
In particular, thoroughly read the “Caution of the product described in this manual” at the start of this
document, and perform a thorough safety check before using the product.
Store this manual in a safe location where it can easily be accessed at any time while you are using
the product.
■
Warranty and Liability Disclaimers
The specifications of the product are subject to change without notice.
Cypress assumes no liability for any loss or damage whatsoever directly or indirectly arising out of
the use of the product.
■
Related manuals
You should refer to the following manuals as well:
Hardware manual of the MCU
“Softune Workbench Operation Manual”
■
European RoHS compliance
Products with a -E suffix on the part number are European RoHS compliant products.
