Software Development
FM4 S6E2H-Series Starter Kit Guide, Doc. No. 002-11387 Rev. **
38
4. Open Watch1 window from
View
->
Watch Windows
.
5. Add the arrays
au32SourceData
and
au32DestinationData
in Watch1 window.
6. Run the program for a while (>10 seconds).
7. Stop the program and check the arrays mentioned above. The Program Counter (PC) will
stop at the routine as shown below which means the content of the arrays are the same.
You can also verify the content of the arrays in the watch window.
4.2.3 Flash Write
4.2.3.1 Project Description
This project demonstrates the flash writing operation of the S6E2HG device. A specific set of
four values each of four bytes in size will be written into a specific address location in the flash
memory.
4.2.3.2 Hardware Connection
No specific hardware connections are required for this project. All connections are hardwired on
the board.
4.2.3.3 Verify Output
4.2.3.3.1 Instructions for IAR Embedded Workbench
1. Power the FM4 S6E2H-Series Starter board from CN3 using a USB cable, refer to
