Installation and Test Operation
FM4 S6E2H-Series Starter Kit Guide, Doc. No. 002-11387 Rev. **
19
Blue LED (RGB LED) Test
: This procedure will test whether blue LED works normally.
Key in
3
to run the test procedure and the blue LED will blink. Then press the
Enter
key
on the PC to complete the test.
TESTED
will be displayed as shown in
Figure 2-13: Blue LED Test
SW2 User Key Test
: This procedure is to test switch SW2. Key in
4
, and then press
SW2 on the starter board. The RGB LED (LED2) will glow green while SW2 is held down.
Release SW2 and press the
Enter
key
to complete the test. It will display
OK.
Figure 2-14: SW2 User Key Test
