Demo System
FM3 Family Math and Motor Control Library Quick Start Guide, Doc. No. 002-04766 Rev. *A
5
Figure 1-2. Hall Signal Line Connection
Note:
If there are only 2 hall signals on the motor, the hall A and B line can be only connected to the inverter’s Hall A and Hall B
port. Don’t connect on the Hall C port on the board.
VCC and GND must be connected rightly, otherwise the hall won’t work right and the motor will also not run.
2. Plug the U, V, W phase lines to inverter board, shown as below.
Figure 1-3. Motor Line Connection
3. Connect JTAG to adapter, shown as below.
Motor Phase Line
Hall port
