CY8CKIT-043 PSoC® 4 M-Series Prototyping Kit Guide, Doc. #: 001-97606 Rev. **
27
Hardware
Figure 4-6. J7 and J3 Headers
When the boards are separated, the KitProg board can be used to program any other PSoC 3,
PSoC 4, or PSoC 5LP device family member via J7.
4.2.5.3
Functionality of J8 and J9 Headers (KitProg)
The KitProg board contains two, dual-inline, headers (J8 and J9). Both are 1×7-pin-headers, used to
provide access to several pins of the PSoC 5LP to support advanced features such as a low-speed
oscilloscope and a low-speed digital logic analyzer. These headers also contain the KitProg bridge
pins (USB to UART and USB to I
2
C) that can be used when the two boards are separated.
The J8 and J9 headers support 100-mil spacing, so you can solder connectors to connect the
KitProg board to any development breadboard.
Figure 4-7. J8 and J9 Headers
Table 4-3. Pin Details of J7 Header
Table 4-4. Pin Details of J3 Header
PSoC 5LP KitProg Header (J7)
Pin
Signal
Description
J7_01
VTARG
Power
J7_02
GND
Ground
J7_03
P12.4 PROG_XRES
J7_04
P12.3
PROG_SWDCLK
J7_05
P12.2
PROG_SWDIO
PSoC 4 M-Series Prototyping Kit GPIO (J3)
Pin
Signal
Description
J3_01
VTARG
Power
J3_02
GND
Ground
J3_03
XRES
XRES
J3_04
P3.3
SWDCLK
J3_05
P3.2
SWDIO
