EZ-USB Development Kit User Guide, Doc. # 001-66390 Rev. *D
115
A.4
Frequently Asked Questions
Q1:
What is the first step, after viewing the printed material from the box?
A1:
Make sure the hardware works well enough to run the tutorial. After software installation, plug in
a development board; go through the DVK tutorial. The tutorial is located in the
EZ-USB DVK User
Guide
, which is found in the Start menu under
Cypress
>
USB
>
Help
. The tutorial is short and
worthwhile.
Q2:
What is the first example to try?
A2:
While following the tutorial, you will read the Device ID from the development board, and then
load the dev_io example. This turns on the LED so you know that firmware has been loaded and
runs correctly.
Q3:
Where do I find the soft copy of the
EZ-USB Getting Started
?
A3:
See
<Installed_directory>\<Version>\Documentation\EZ-USB (R) DEVELOP-
MENT KIT USER GUIDE.pdf.
Q4:
Where do I find the soft copy of the
EZ-USB Technical Reference Manual
(TRM)?
A4
: See
<Installed_directory>\<Version>\Documentation\EZ-USB(R) Technical
Reference Manual.pdf
. This is the key reference to use. You can search for the material you are
most interested in quickly.
Q5:
Where is the EZ-USB data sheet?
A5:
See
<Installed_directory>\<Version>\Documentation\EZ-USB FX1 Data-
sheet.pdf
for the CY3674 and <
Installed_directory>\<Version>\Documentation\EZ-
USB(R) FX2LP Datasheet.pdf
for the CY3684.
Q6:
Where is the EZ-USB Development Board schematic (pdf and Orcad files)?
A6:
See
<Installed_directory>\<Version>\Hardware
for EZ-USB Kits .
Q7:
Where can I find the errata?
A7:
See
<Installed_directory>\<Version>\Documentation\SILICON ERRATA FOR
EZ-USB(TM) FX1 PRODUCT FAMILY.pdf
for the CY3674 and
<Installed_directory>\<Version>\Documentation\ERRATA FOR THE EZUSB-
FX2LP.pdf
for the CY3684.
Q8:
How do I to generate "myapp" from (frameworks)?
A8:
Create a (frameworks based) project folder by copying the ‘fw’ example folder
<Installed_directory>\<Version>\Target\Fw\LP
a new location (under ‘Examples’).
Then rename the folder to the new project name. Remove the .hex file, and .Uv2 file. Rename
periph.c to <NewPrj>.c, and then create a new uV2 project file. See
Q9:
How do I build an EEPROM image to burn my code?
A9
: See the tutorial for information about generating EEPROMs.
Q10
: Where can I get a summary of the registers?
A10:
See the register summary in the TRM.
Q11:
Are there any examples?
A11:
Yes, see the examples and readme files in the Examples folder.
Summary of Contents for CY3674
