13
1) Audio over IP:
This section allows control over selection of the input
source, enabling/disabling the audio mute, changing the microphone
volume, and front panel locks.
Audio Select:
Select between the optical, line or mic inputs on the
transmitter.
N
ote: Input selection is only available when linked directly to a
compatible dedicated audio transmitter.
Audio Mute:
Enable or disable muting the audio output.
Analogue Output Volume:
Increase or decrease the audio volume
of the analogue audio output by dragging the slider.
Front Panel Lock for Device Button and Knob:
Enable or disable
either of these lock types for the front panel. When the locks are
enabled, the user can only change settings using the WebGUI or
Telnet commands.
2) Serial over IP:
This section provides controls for the Serial over IP
extension functionality, including enabling/disabling serial support
and setting the RS-232 data configuration.
Enable Serial over IP:
Unchecking this checkbox will completely
disable support for sending RS-232 commands over this stream.
This option should generally remain checked, but, if serial support
is not required, disabling this feature can save a very small amount
of bandwidth.
Serial Settings:
Set the desired baud rate, data bits, parity, and
stop bit for the RS-232 signal to extend.
Note: The transmitter and receiver must have the same serial settings.
Summary of Contents for IP-A750RX
Page 1: ...IP A750RX Audio over IP Receiver for IP 7000 series OPERATION MANUAL ...
Page 2: ......
Page 31: ......