CYP CLUX-1HLR, Operation Manual

Page: 21 / 48

16
6.3.5 Customized Video Wall Layouts
The position, size and angle of the display connected to each unit is
set in the Layout window when in Rotation Mode. If you are currently
in the Setting window, clicking on the “Layout” button in the upper-
left “Common” section of the window will switch back to the Layout
window and activate Rotation mode.
The outline of the layout window represents the source video
(1920×1080 pixels) and each display must be placed within this space,
without exceeding the edges (not including bezel size, if active). Each
display contains a number which matches the ID number of the unit
that is connected to it and the size/position of each display (listed
to the left) is measured in pixels relative to its size/position within the
layout space. When a bezel measurement is used, the display width/
height measurement should be the total measurement of the screen
plus the bezel.
Note: Video wall configuration and warping is not available in Scaler
Mode.
This control software provides a number of common, pre-defined,
video wall configurations, however in most cases a customized layout
will be needed. Custom layouts are created by selecting a layout to
use as a basis, and then right-clicking on the layout’s selection button
and selecting “New” from the dropdown. You then provide a name
for the new layout and click “OK” to generate it. Custom layouts are
colored differently to make them easy to identify.