CYP CLUX-1HLR, Operation Manual

Page: 19 / 48

14
6.3.4 Pre-Defined Video Wall Layouts
The position, size and angle of the display connected to each unit is
set in the Layout window when in Rotation Mode. If you are currently
in the Setting window, clicking on the “Layout” button in the upper-
left “Common” section of the window will switch back to the Layout
window and activate Rotation mode.
The outline of the layout window represents the source video
(1920×1080 pixels) and each display must be placed within this space,
without exceeding the edges (not including bezel size, if active). Each
display contains a number which matches the ID number of the unit
that is connected to it and the size/position of each display (listed
to the left) is measured in pixels relative to its size/position within the
layout space. Pre-defined layouts do not include bezel compensation.
Note: Video wall configuration and warping is not available in Scaler
Mode.
This control software provides a number of common, pre-defined,
video wall configurations which can be selected and easily applied
to any connected units. All pre-defined configurations are designed
around video walls containing 4 displays.
1) Selecting Pre-Defined Layouts: Select any of the provided pre-
defined layouts from the right-hand scroll bar. After selecting a
new layout, you must confirm that you wish to leave the current
layout.
Note: It is not possible to save changes to the pre-defined layouts.
Switching to a new layout will remove any changes made to the