CYP CLUX-1HLR, Operation Manual

Page: 13 / 48

8
6.3.3 Basic Unit Settings & Configuration
The basic configuration and settings for each connected unit can be
set by selecting the unit to configure from the “Unit” section and then
clicking on the “Setting” button in the upper-left “Common” section of
the window. The operational mode of the unit (Rotate Mode or Scaler
Mode) may be set here, as well as the Ethernet, I/O, and mode-
specific image features. To exit the setting configuration tabs and
return to the layout mode, click on the “Layout” button in the upper-
left “Common” section of the window.
Note: Some configuration options are not available in both modes.
The “General” tab provides control over the network configuration,
and provides a way to initiate a firmware update or perform a factory
reset. This tab provides the same options in both operational modes.
1) System Setup: Displays the current firmware version and provides
options to update the firmware or perform a factory reset on the
unit.
■ Update FW Button: Provides a way to update the unit’s
firmware. Insert a USB thumb drive, with a valid firmware file
(*.bin format) in the root directory, into the unit’s USB service
port then click the “Update FW” button. After the update is
complete the unit will automatically reboot.
■ Factory Reset Button: Selecting this will reset the unit’s settings
back to their factory defaults.
2) Network Configuration: The IP Address, Netmask and Gateway
can be set manually, or DHCP can be enabled for automatic IP