CYP CH-1539TXPLPD, Operation Manual

Page: 16 / 44

11
■ HDCP: The HDCP mode of each input can be set to “Follow Source”,
“Follow Display”, or “Disabled”. Changes made to this setting occur
immediately.
Note: The VGA input cannot support HDCP.
6.5.2 Automation Tab
The Automation tab provides control over the unit’s automatic control
command broadcast behavior when any of the specified Automation Events
occur. Automation commands are sent to the connected display device via
standard CEC.
1) Event: Use the dropdown to select the Automation Event to configure.
Available Automation Events are:
– Power On:
This unit is powered on.
– Out A Source Active:
The currently selected input changes from
inactive to active.
– Out A Source Lost:
The currently selected input changes from
active to inactive.
■ CEC:
Enable or disable sending a CEC command when the currently
selected Automation Event is activated.
Note: CEC support must also be enabled on the connected HDMI
display device.
■ Delay: Set the length of time, in seconds, that the specified
Automation Event must continue to be true before sending the
defined command.