Cynosure Acclaim 7000, Technical Manual

Page: 70 / 74

Page 66 of 70 850-1257-000, Rev. 2 Cynosure, Inc.
Self Test
During startup, the lasers run a self test. If any critical area fails the self test or fails during
operation, a system fault and a fault code appears on the display. See “Critical Faults” on page
65 for fault code definitions.
Miscellaneous Troubleshooting
Problem Possible Cause Solution
Laser does not start. Power is not properly connected. Connect power cables.
Check that laser’s main
circuit breaker is in the on
position.
The keyswitch is OFF. Turn the keyswitch to
START and let it return to
ON.
Lasers not up to operating temperature. Allow laser to run until
WARM UP message is off.
Check that no other fault messages are
displayed. Correct any conditions as
indicated by fault
messages.
Laser will not go into
Standby Mode.
Standby Key ( ) not activated or not
working.
Press Standby Key ( ).
Laser will not enter Ready
Mode. Operator switch activated. Check that finger switch or
foot switch is not being
pressed.
Ready Key ( ) not activated or not
working.
Press Ready Key ( ).
Laser not properly calibrated as
indicated by Front Panel Display Recalibrate Laser.
Fiber cable not connected. Check that handpiece fiber
cable is properly
connected.
Ready LED lit, but laser will
not fire outside of Cal Port.
Foot switch not connected. Check that foot switch
connector is properly
inserted into foot switch
receptacle.
NOTE: If any problems occur that are not covered in the troubleshooting chart, or the suggested
solutions do not work, call the Cynosure Service Department at (888) 523-2233, FAX (978) 256-
6556 or Service FAX at (978) 256-4888.