CynkoMet T-169/1, Instructions For Use And Operation

Page: 51 / 144

Cynko Met
T-169
Page
51
You should aim for even load distribution in the loading
crate. When loading, it is recommended to use a crane, loader or
conveyor. Before loading, check that the locks, wall hinges and the
dump window in the rear wall are closed. If the trailer is equipped
with tarpaulin, then before loading from "above" you should
remove the tarpaulin and / or disassemble its frame.
When transporting materials exerting point pressure on the
floor of the loading crate (e.g. large stones). before loading you
should plant thick boards, thick plywood, etc. This will enable to
achieve an even surface of the floor load and protect it from
damage.
Lightweight, volumetric materials may be loaded above
loading crate extensions, but no more than 5cm above them,
paying particular attention to the stability of the trailer and cargo,
and protection against road littering. When transporting light
materials, it is not allowed to mount cables connecting the wall.
In
other cases, springs must always be installed.
Regardless of the type of the load carried, the user is
required to secure it in such a way that the load is not able to
move freely and cause contamination of the road. If this is not
possible, it is prohibited to transport such cargo.
Due to the varied density of the materials, the use of the total
capacity of the container may result in exceeding the permissible
load of the trailer.
The approximate permissible heights of loading layers of
various materials and their bulk weights are given in Table 3.