Placing the dishwasher
The dishwasher is intended to be built-in under a worktop.
The built-in measurements are shown in the illustration.
Make sure that the cable and hose hole’s edges are even
and will not damage the drainage and inlet hoses or the
power cable.
570
55
125
820-893
600*
[mm]
Exercise caution! The edges may be sharp. Wear protective
gloves!
* Remove the plastic
strips if the recess
dimension is
597--600
mm .
If the dishwasher is built-in the surrounding furnishings must
be resistant to any condensation from the dishwasher.
Affix the protective film
Affix the protective film (packed in the document bag) to the
underside of the worktop. The protective film is to protect
the worktop from moisture.
NOTE!
The surface to which the protective film is affixed must
be clean and dry.
Adjust the height and slide the dishwasher
into place
1. Start by measuring the height from the floor to the bot-
tom edge of the worktop.
2. Measure the height from the floor to the top edge of the
dishwasher.
3. Adjust the front feet by turning them clockwise to raise
and anticlockwise to lower the dishwasher.
Lean the dishwasher forwards a little and adjust the rear
foot with the screw at the front of the dishwasher. Turn
clockwise to lower or anticlockwise to raise.
Max 0.6 Nm
2x
4. Check that there is an air gap of at least 3 mm between
the underside of the worktop and the top edge of the
dishwasher.
5. Slide the dishwasher into place.
•
Pull through the drainage and supply hoses when
the machine is slid into place.
•
Check that the hoses have no kinks or sharp bends,
and check that there is nothing that can damage the
hoses.
•
Check that the machine is installed such that the
door opens freely, otherwise door lock functionality
may be disrupted.
6. Make any final adjustments to the front feet (the dish-
washer may lean no more than 5 mm).
Drainage connection
This dishwasher is suitable for installing in a raised recess
(to attain an ergonomic working height). This means that
the dishwasher can be placed so that the drainage hose
runs to a lower level than the bottom of the dishwasher,
such as by routing it directly to a floor drain. The dishwasher
is fitted with an integrated anti-siphon device to prevent the
machine from being emptied of water during the wash cycle.
min.
14 mm
41
EN
