~6~
In the main menu, the first three characters
to
represent the number of the main program in which you
are located. Moving in subprograms, the first character from
to
denotes in which subprograms the main
program derives. The second digit on the display represents the number of the subprogram, e.g.
means that we
are in program No. 3 and subprogram No. 5.
3.1.
A program containing all PC-4000 panel settings
To enter the settings, press the key. You have a choice of 9 subprograms described below:
3.1.1.
In this subprogram, the panel operation mode should be configured. You can choose MASTER and SLAVE panels.
The SLAVE panel is always assigned to specific control electronics and creates a set of one entry/staircase
panel-control panel. MASTER panels are not assigned to any control panel and are able to communicate and
call/open any CC-4000 electronics connected to the system. The Master type is used only for systems with an input
hierarchy.
To pair the panel with the CC-4000 electronics, select
(Now the serial
number of the control panel, e.g. 000000, that is currently stored in the panel will be displayed).
(At this point, enter the serial number of the control panel with which you want to pair the
panel).
(If the control panel is correctly connected and the correct serial number has been
entered, the system number of the control panel will be displayed).
(At this point it is
possible to assign the CC4000 electronics a system number which can be change using the '1', '4', '3', '6', keys). The
panel will confirm the correctness of the programming with the following message:
.
To
configure
the
panel
as
Master
with
simple
dialing:
. A panel configured in this way will be able to call any subscriber in the
system (1-9999). It is important that the subscriber numbers do not repeat in any control panel.
To
configure
the
panel
as
Master
for
dialing
with
a
prefix:
. The panel configured in this way will call the control panel
after its system number. That means, you need to first choose the system number of the control panel, then the
subscriber's number. The subscribers' numbers can be repeated in every control electronics.
3.1.2.
A subprogram that limits the range of dialed numbers from the keypad. There are two subranges to be set up. After
selecting a subscriber number outside the permitted range, ER17 error will be displayed.