22
23
Cleanse the treatment area and pat dry. Remember, don’t use any gels or creams with this device!
Step 2:
Doing a TEST PATCH
Before your first treatment on each new body area, we RECOMMEND you test your skin in that area for a reaction to
SmoothSkin Bare+.
The patch test area should be approximately 3cm x 2cm in size (equivalent to 2 flashes applied to the skin side by side). Follow
Step 3 to treat the area.
Always perform a patch test on each new
treatment area
Observe for
adverse events
12
24 HOURS
1
2
3
4
5
6
7
8
9
10
11
Incorrect
Correct
Skin Detection
Indicator On
Indicator Off
No Skin Detection
Treatment Window
Wait 24 hours following the patch test
, to ensure your skin is suitable for treatment and there is no adverse reaction to the light energy. If there is
no reaction after 24 hours, you may treat the area around the patch test. The ‘patch tested area’ should NOT be re-treated for at least 1 week.
Step 3: Treating with the SmoothSkin Bare+
A) Plug the Power Supply into an Electrical Outlet using the provided Power Cable. The Skin Tone Sensor on the front of the Handset will illuminate
blue and the fan will start up.
STANDBY MODE Timeout
When the unit is left “inactive” i.e. no buttons are pushed for 10 minutes then the unit will revert to STANDBY mode, and the STS lights will
switch off. To return to READY mode for treatment, press the Activation Button.
B) Press the Handset firmly against the area to be treated ensuring the Skin Tone Sensor is in contact with the skin. If the Skin Tone Sensor does
not detect a valid skin tone, then the Handset cannot be activated. When the Skin Tone Sensor measures a valid skin tone, the lights around
the Activation Button will illuminate WHITE to indicate the device is ready to flash.
