6
Version 1.0
XLR plug with a 120 resistor connected between pins 2 and 3, which is then plugged into the output XLR
socket of the
last fixture in the chain.
Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120
resistor between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the
last fixture.
Power connection
Power Requirements
The FR-200F luminaire operates on 100 to 240 volts AC (+/- 10%, auto-ranging). The luminaire contains
an auto-ranging power supply.
Power linking between fixtures:
The fixture with powercon in and out socket. Connect the power out to the power in socket in the next
fixture till all are connected.
Caution: maximum power linking - 8 units.
Connection with the mains:
Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection cables as below:
Cable color
Connection
International
Brown
Live
L
Blue
Neutral
N
Yellow/green
Earth(Ground)
Operation
The FR-200F can operate in different modes. In each mode you can run the fixture as a stand alone
fixture or in a master/slave confiugration. This next section will detail the differences in the operating
modes.
Control Menu Map
MENU
SUB MENU
OPERATION
Addr
d001-d512
RDM/DMX address
CHnL
Stag(12CH)
Channel mode
ArC.1(3CH)
Ar1.d(4CH)
ArC.2(4CH)
Ar2.d(5CH)
Ar2.S(6CH)
HSV(3CH)
SP--
T.(00-99)
Auto program speed increasing
Pr--
Pr01~Pr10
Auto programs
CoLo
C.(01~15)
Color preset
Strb
S.01-s.20
Strobe with spead increasing
rL--
r.(000-255)
Red dimmer
gL--
g.(000-255)
Green dimmer
