When running your power and speaker wiring you can use a rigid
ʻ
snake
ʼ
tool (or something similar) to get to the battery area, underneath gas tanks
and around other obstacles. Generally you do not need to remove gas
tanks to install our speaker system and achieved by using this technique.
Start by running the snake tool from the battery area under the tank and
out by the neck of the bike. This may take several tries as this is a tight
location to get through on some bikes. Once the snake tool is at the neck,
tape the wires to it as shown in
Figure 6-2
. Then from the battery area pull
the snake tool underneath the tank bring the wires with it. Once the wire is
run remove the tape from the snake tool.
Fig. 6-2
2.
After you have determined which wires are suitable for accessory power
connection use the supplied connectors to easily wire power to the
vehicle. First, take the Red Locking Connector
(15)
and place it around the
vehicle accessory power wire as shown in
figure 6-3
and press it together
with a pair of pliers until it locks.
Fig. 6-3
3.
Then, cut the pin connectors from the end of the power harness and strip
off approximately 1/2" of wire
(figure 6-4)
. Using a pair of suitable wire
crimpers attach the Blue Male Connector
(16)
to the red wire on the power
harness . Once this is securely connected plug the Blue Male Connector
into the Red Locking Connector as shown in
figure 6-5
.
Fig. 6-4
Fig. 6-5
