Qty
Description
Item
1
Backing
1
1
Front sheet
2
1
Weight decals
3
2.
Place decals front sheet in the correct position on weight plates.
3.
Insert a guide pin through each hole of the decals front sheet. (A guide pin can be anything that fits through
the weight stack hole, such as a weight stack selector pin.)
4.
Align decals and rub them onto weight plates.
5.
Remove front sheet, do not peel decals off of weight plates.
Qty
Description
Item
1
Weight stack selector pin
1
1
Weight plate decals
2
6.
Repeat above steps for other half of the weight plate decals.
Cable routing
1.
Verify cable is routed through pulley brackets.
2.
Verify cable is not twisted.
3.
Turn the Increment Weight Adjusting Knob to select 0 lbs or 0 kg.
4.
Place weight stack pin in each plate to verify proper installation.
5.
Simulate normal operation by lifting top weight up and down without selecting any resistance.
6.
Verify that the cable is moving smoothly and is routed straight from the top pulley bracket to the top weight
pulley bracket.
Install back panel
Slide back panel down into extrusions.
Page 14 of 25
