5. Route cable up through the top of the tower frame and down through the side tube of the frame.
Item
Description
Qty.
1
Cable
1
6. Install screws, washers, spacers, and nuts securing the pulleys to the top of the tower frame using an 8mm Allen wrench and
17mm wrench.
NOTE:
Make sure the spacers are centered and inside the tube wall.
Item
Description
Qty.
1
Pulley, 3.5" OD
1
2
Pulley, 4.5" OD
1
3
Cable
1
4
Screw, M10 x 1.5, 55mm
2
5
Nut, M10 x 1.5, Hex Nylock
2
6
Washer, Flat 3/8" ID
4
7
Bushing
4
Tighten hardware to 14-16 ft-lb (19-21.7 Nm).
NOTE:
Make sure cable is routed over the pulleys and underneath the pins in the tower frame.
7. Flex rear shroud into position inside the tower frame.
Page 15 of 36
