CYBEX 8800, Owner'S Manual

Page: 21 / 34

4-5
Product Number 8800/8810/8830/8840 Owner’s Manual
BHSCS
Locknut
BHSCS
Figure 9
Figure 8
Insert
plug
Chin-Up Bar
Remove insert plug to gain access to BHSCS securing Chin-Up Bar. See Figure 8. C. NOTE: 8810
/8840 units are not shipped with Chin up bar attached (refer to step 13).
Repeat step 10C for insert plug on opposite side. D.
Locate BHSCS on top of frame near pulley. See Figure 9 E.
.
Insert
plug
8. Cable routing.
Verify cable is routed through top of pulley bracket and then route cable end to top weight A.
connector.
Pull cable tight and secure in place with roll pin removed in step 6H. B.
Place weight stack pin in each plate to verify proper installation. C.
Without selecting any resistance, lift top weight up and down (simulating normal operation). D.
Have an assistant verify that the cable is moving smoothly and is routed straight from the pulley E.
bracket to the top of the weight plate connector.
9. Install back shrouds.
Carefully place shrouds into position. A.
Secure top cap in place with the two BHSCS removed in step 6A. B.
10. Separate frame for 8800/8830 (If needed to fi t thru doorway).
Remove shipping pallet (refer to step 4). A.
Locate insert plug. See Figure 8. B.