CYBEX 8800, Owner'S Manual

Page: 22 / 34

Product Number 8800/8810/8830/8840 Owner’s Manual
4-6
Verify all BHSCS are securely tightened. O.
Insert plugs removed in step 10C for 8800/8830 or from hardware pack for the 8810/8840. P.
11. Install weight plates, decals, cable routing and, shroud assembly for 8800/8830.
Refer to step 6A - 9B for weight plates, decals, cable routing, and shroud assembly. A.
12. Separate Frame for 8810/8840 (If needed to fi t thru doorway).
Remove shipping pallet refer to step 4. A.
Refer to steps 10J - 10N. B.
13. Install Chin Up Bar (8810/8840 units only).
Locate Chin Up Bar and hardware. A.
With an assistant, align Chin Up Bar in place. B.
Place a drop of Loctite 242 on BHSCS from hardware bag and threaded holes. C.
Secure Chin Up Bar with hardware from hardware bag. D.
Verify all BHSCS are securely tightened. E.
Carefully slide top weight (removed in step 6J) over guide rods. F.
Insert plugs from hardware bag. G. NOTE: Refer to step 10B for location of plugs.
Using a 7/32” Allen wrench remove two BHSCS securing Chin-Up F.
Bar
Using a 7/32” Allen wrench and socket remove two BHSCS secur- G.
ing Chin-Up Bar.
Repeat step 10E and 10F for opposite side H.
Carefully remove Chin-Up Bar and set aside. I.
With an assistant remove 4 (of 8) BHSCS securing frame halves J.
See Figure 10.
Move to desired location. K.
Place both halves of frame together and tightly secure the four L.
BHSCS removed in step 10J.
Place a drop of 242 Loctite on BHSCS and threaded hole removed M.
in step 10J.
With an assistant secure Chin-Up Bar in place removed in N.
step 10I.
Figure 10
BHSCS