![background image](http://html1.mh-extra.com/html/cybex/400t/400t_owners-operating-manual_2703694045.webp)
39
6 / T
ROUBLESHOOTING
nn 4: Check Deck Wear
This message appears every 2,500 miles (4023 km).
The treadmill running deck should be checked routinely for signs of
wear. Any signs of abnormal deck wear, such as excessive
furrowing, scraping, cracking, fissures, or burnt or insufficient wax,
may indicate the need for deck replacement.
The front and rear rollers should also be checked for any signs of
build-up of wax or other foreign materials and cleaned if necessary.
Note: Maintenance instructions relative to nn1 also apply at this mileage.
nn 5: Lubricate Elevation
This message appears every 5,000 miles (8047 km).
The elevation jack screw should be lubricated to assure proper
performance. First remove any old grease and accumulated dirt
from the jack screw using a clean, dry cloth. Next, use lithium
grease to lubricate the screw; lithium grease can be purchased
from a hardware store or appliance repair shop. Apply the new
lubricant liberally, using a small bristle brush to help spread the
lubricant in and around the screw threads.
Proper lubrication will help the jack screw turn smoothly, reducing
wear on the elevation drive motor system.
Other Service Recommended
In addition to the above five service reminders, Cybex
recommends that a qualified Cybex treadmill repair technician
should rotate the deck and replace the running belt at 7,000 miles
(11265 km). There are no service prompts for these.
Error Codes
ERR 1: NO SPEED SIGNAL AT STARTUP
ERR 2: EXCESSIVE CURRENT DRAW
ERR 3: LOSS OF SPEED SIGNAL
ERR 4: NO FREQUENCY LOCK
ERR 5: ELEVATION ERROR
ERR 6: OVERSPEED
ERR 7: LOSS OF NOVRAM
If you have a problem that interrupts an important operational area
of the treadmill, you may see one of the above error codes
displayed in the control panel. If an Error Code is generated during
operation, the treadmill’s drive motor will stop. In order to restart
the treadmill, the Error Code must be cleared by cycling the power
to the machine by switching the ON/OFF switch to “OFF” for 5
seconds and then switching it back “ON” again. Should a message
reappear soon after cycling off, then on again, report the problem
to your dealer or to CYBEX Customer Service.
Summary of Contents for 400T
