4
5. Press the power switch to turn the unit on. The Power On indicator light will illuminate and the unit will “beep”.
If an overload is detected, an audible alarm will sound and the unit will emit one long beep. To correct this,
turn the UPS off and unplug at least one piece of equipment from the battery power supplied outlets. Make
sure the circuit breaker is depressed and then turn the UPS on.
6. To maintain optimal battery charge, leave the UPS plugged into an AC outlet at all times.
7. To store the UPS for an extended period, cover it and store with the battery fully charged. While in storage,
recharge the battery every three months to ensure battery life.
8. To use PowerPanel® Business Edition software, connect the serial cable to the serial port or the USB port on
both the UPS and the computer. These OR units include one serial port and one USB port to allow
connection and communication between the UPS and computers. The primary computer (with PowerPanel®
Business Edition installed) is the computer that you will use to control the UPS and make changes to the
operation of the UPS. [Note: only one port (USB or Serial) can be used at a time. When one port is in use, the
other port will be disabled.] When there is a power failure, the computer connected to the port will start to shut
down after a user controlled delay. PowerPanel® Business Edition will save and close any open files prior to
shutting down the system.
DESCRIPTION
BASIC OPERATION
Or
