įĂĀĂĀƫ5!.ƫ+3!.ƫ5/0!)/ƫĨĩČƫ *ċƫ((ƫ.%#$0/ƫ.!/!.2! ċƫ((ƫ+0$!.ƫ0. !).'/ƫ.!ƫ0$!ƫ,.+,!.05ƫ+"ƫ0$!%.ƫ.!/,!0%2!ƫ+3*!./ċƫ
25
USING THE UPS SYSTEM CONT.
LCD Configuration Settings Cont.
CONFIGURE
SUBMENU
AVAILABLE SETTINGS
DEFAULT SETTING
ECO Mode
1
[Disable] [Enable]
Disable
[V Range= +/-15%] [V Range= +/-10%] (for [Enable])
When ECO mode is enabled the UPS will check the
following bypass quality specifications
(1)
Bypass voltage is inside the [V Range= +/-10%]
(default setting) or [V Range= +/-15%]
(2)
Bypass frequency is inside the +/-3 Hz range of
output nominal frequency
V Range= +/-10%
Manual Bypass
[Disable] [Enable]
When performing UPS maintenance, the user can
manually transfer the connected load to bypass
without interrupting the supply of power.
Disable
UPS Diagnostic
[Battery Test] [Alarm Test] [Indicator Test] [Fan Test]
[Battery Test]
[Activate?]
Starts a manual battery test. The UPS will operate 10
seconds on Battery Mode to check battery condition.
Starts a manual alarm test. The buzzer will sound
for 5 seconds.
Starts a manual indicator test. The UPS will turn on all
LEDs and light the LCD background for 5 seconds.
Starts a manual fan test. The UPS will operate fans at
full speed for 5 seconds.
None
Audible Alarms
[Disable] [Enable] [Only Battery Low]
User can [Disable] or [Enable] the audible alarm and
can also set [Only Battery Low] to alarm only when
the battery is low in Battery Mode.
Enable
EBM Number
= [0] [1] [2] [3] [4] [5] [6] [7] [8] [9] [10]
Set the number of EBM (Extended Battery Modules)
to get the correct estimated runtime.
0
Wiring Fault
[Disable] [Enable]
Set [Disable] or [Enable] to automatically check
for an input wiring fault.
Disable
NCL Control
[Outlet On] [Outlet Off]
Set Noncritical Load (NCL) [Outlet On] or [Outlet
Off]. When NCL is set to [Outlet Off], the NCL
output power will turn off immediately.
Outlet On
