© 2010 CyberPower Systems (USA), Inc. All Trademarks are property of their owners.
Page: 8 of 17
4.2 Unpacking
Inspect the Battery Backup Unit upon receipt. The box should contain the following:
• Battery Backup Power Supply Unit x 1
• Battery Shelves x 2
– Battery Tray x 2
– Battery Tray Clamp x 2
– M4 x 8 Truss head Screws x 8 (secure clamp to shelf)
– M4 x 8 Truss head Screws x 4 (secure shelf to enclosure)
• Accessory Pack
– Terminal Connectors x 2
– Cable Ties x 6
– Battery Terminal Jumper x 6
– Battery Wire Harness Assemblies x 2
– User’s Manual x 1
• Wall Mount Kit
– Wall Mount Bracket x 2
– M8 Flange Nut x 4
• (OPTIONAL) Pole Mount Kit
– Pole Mount Bracket x 3
– M8 Flange Nut x 6
– M8 x 25L Hex Head Screws (clamp center bracket to side brackets) x 4
– M8 Lock Washers x 4
– M8 Flat Washers x 4
• (OPTIONAL) Battery Heater
– Battery Heater Sheet x 1
– Circuit Breaker with Outlet x 1
4.3 Prior to Installation
Installation of the unit must be performed by skilled technicians and electricians familiar with
electrical equipment. Do not allow unqualified personnel to handle, install, or operate the
equipment. The installation must comply with both the requirements of the National Electrical
Code (ANSI/NFPA 70, latest issue), and local codes.
CAUTION:
When batteries are installed in the UPS, the total weight will exceed 50 pounds. Make
sure the fasteners used to attach to the wall are of sufficient strength to securely hold the UPS.
