FCC Notice
This equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures: (1) Reorient or relocate the receiving
antenna. (2) Increase the separation between the equipment and receiver. (3) Connect the equipment into an outlet
on a circuit different from that to which the receiver is connected. (4) Consult the dealer or an experienced radio/TV
technician for help. Any special accessories needed for compliance must be specified in the instruction.
CAUTION:
A shielded-type power cord is required in order to meet FCC emission limits and also to prevent interfer-
ence to the nearby radio and television reception. It is essential that only the supplied power cord be used. Use only
shielded cables to connect I/O devices to this equipment.
CAUTION:
Any changes or modifications not expressly approved by the guarantee of this device could void the user’s
authority to operate the equipment.
PowerPanel™ is a trademark of CyberPower Systems (USA), Inc.
For more information, contact us at:
CyberPower Systems (USA), Inc.
5555 12
th
Avenue East, Suite 110
Shakopee, MN 55379
Tel: (952) 403-9500
Fax: (952) 403-0009
Toll-Free: (877)-297-6937
Email:
Web:
www.cyberpowersystems.com
Entire contents copyright ©2003 CyberPower Systems, Inc.
All rights reserved. Reproduction in whole or in part without permission is prohibited.
