Installing the VoIP V2 Paging Amplifier
Paging Amplifier Setup
Operations Guide
930363B
CyberData Corporation
7
2.2.1 Paging Amplifier Components
Figure 2-3
shows the components of the Paging Amplifier .
Figure 2-3. Paging Amplifier Components
DIP Switches
Speaker Volume
Network Link LED (
GREEN
/
YELLOW
)
Status LED (
GREEN
)
A steady LED confirms that the Paging Amplifier is operational.
The LED will blink during a page when it is online.
Network Activity LED (
GREEN
)
Power LED (
GREEN
/
BLUE
)
The power LED is a steady
green
in low power mode and
a steady
blue
during high power mode. The power LED
will only blink either during a boot up or a phone call.
RTFM Switch
To broadcast a Paging Amplifier’s current IP address,
press and hold the RTFM switch until you hear the IP
address announcement, and then release the RTFM
switch.
To restore the factory defaults, complete the following
steps:
1. Press and hold the RTFM switch until you hear the IP
address announcement. Continue holding the RTFM
switch for an additional five seconds until you hear the
Paging Amplifier announce the words, “restoring defaults”
and “rebooting”.
2. Release the RTFM
switch. The Paging Amplifier will be
restored to the factory default settings.
