Installing the VoIP V2 Paging Amplifier
Paging Amplifier Setup
Operations Guide
930363B
CyberData Corporation
14
2.2.6 Confirm the IP Address and Test the Audio
2.2.6.1 RTFM Switch
When the Paging Amplifier is operational and linked to the network, use the Reset Test Function
Management
(RTFM)
switch (
Figure 2-13
) on the Paging Amplifier face to announce and confirm
the Paging Amplifier’s IP Address, and test that the audio is working.
Figure 2-13. RTFM Switch
Announcing the IP
Address
To announce a Paging Amplifier’s current IP address:
1. Press and hold the RTFM switch until you hear the IP address announcement.
2. Release the RTFM switch.
Restoring the
Factory Default
Settings
To restore the factory default settings, complete the following steps:
1. Press and hold the RTFM switch until you hear the IP address announcement. Continue holding
the RTFM switch for an additional five seconds until you hear the Paging Amplifier announce
the words, “restoring defaults” and “rebooting”.
2. Release the RTFM switch. The Paging Amplifier will be restored to the factory default settings.
RTFM switch
Caution
Equipment Caution:
Pressing and holding the RTFM switch for more than five
seconds after the IP address announcement will restore the V2 Paging Amplifier
to the factory default settings. See the “
Restoring the Factory Default Settings
”
section.
GENERAL ALERT
