User's Manual
V34bis Fax-modem - AJ 2885 P
AJ 2885 P - Page 21
4.1.4. Configuration
Select
Holding MODE for more than 10 seconds will initiate a hardware reset.
If the switch is still pressed after some beeps are heard at power-up, the modem will enter
configuration mode.
The front panel LEDs DTR, DSR, CD and LINE indicate which configuration the user can select.
There are listed in the following table:
DTR
DSR
CD
LINE
Configuration
0 0 1 1 Factory
configuration
"0" async dial configuration
(AT&F0)
0 1 0 1 Factory
configuration
"1" sync 2WLL configuration
originate (AT&F1)
0 1 1 1 Factory
configuration
"2" sync 2WLL configuration
answer (AT&F2)
1 0 0 1 Factory
configuration
"3" V25bis HDLC dialer (AT&F3)
1 0 1 1 Factory
configuration
"4" V25bis BSC dialer (AT&F4)
0
0
1
0
User configuration "0" (AT%M0)
0
1
0
0
User configuration "1" (AT%M1)
0
1
1
0
User configuration "2" (AT%M2)
1
0
0
0
User configuration "3" (AT%M3)
1
0
1
0
User configuration "4" (AT%M4)
Each of the configuration will stay on for 2 seconds while the MODE button is pressed.
Releasing the button will select the new configuration, and this configuration will be loaded after
power up. Immediately after the power up test (after the beeps), the LEDs will indicate which
configuration is loaded for 2 seconds.
4.1.5. Factory configuration detail
The following parameters differ from the factory 0 configuration.
•
Factory 1 : E0 Q1 &D0 %D2 &C1 %C1 &R0 @A0 &M1 &L2 *LG0 *M1
•
Factory 2 : E0 Q1 &D0 %D2 &C1 %C1 &R0 @A0 &M1 &L2 %O0 *LG0 *M1
•
Factory 3 : E0 %D2 &C3 %C3 &R0 @V3 %B1 @A0 &M1 *LG0 *M1
•
Factory 4 : E0 %D2 &C3 %C3 &R0 @V4 %B1 @A0 &M1 *LG0 *M1
These configurations may change without notice. Please check on your modem.
