9
11
8
10
Memory Mode
Memory Mode
Memory Mode
Troubleshooting
The ambient (room)
temperature was
outside the operating
range. Keep it at room
temperature (approx.
) for 30
minutes before using.
Poor contact caused
the thermometer to
thermometer will
power off
automatically. Please
measure again.
Cleaning
and
Care
Z
Z
Z
Recalling Memories:
60~104°F
stop measuring. The
The thermometer has
malfunctioned. Please
contact distributor
Indicates a low battery
condition. Replace with
2 new “AAA” batteries
as soon as possible.
1. Begin with the unit turned off.
2. Press the POWER button and hold for
approximately 3 seconds until the most
recent memory is shown, then release.
3. Press and release the button again and
again to scroll through the remaining
previous memories.
Etc...
4. When you are finished viewing stored
memories, discontinue pressing the
button. After a short pause, you will
hear 2 beeps indicating the unit is
ready to take a new measurement.
Ready to
measure
Deleting Memories:
If you choose to delete memories on the
thermometer, this may be done after
step 2 or 3 of
Recalling Memories
.
1. As you are scrolling through and viewing
stored memories, at any time you may
press and hold the POWER button for
3 seconds until
dEL
displays - then
release the button.
It is not necessary to delete memories, it
is simply an option. Oldest memories will
automatically be deleted as you take new
measurements. Removing the batteries
will also delete all memories from the unit.
~ NOTE ~
ALL memories will be deleted in this process,
you cannot delete just one single memory
2. While
dEL
is still displayed,
press and
release
*
the POWER button once more
to finish the delete process.
OFF
will
show on the display and all stored
memories are now deleted.
*
If you do not press and release the POWER
button in this step, the thermometer will
return to recalling memories
Do not drop the unit or
expose to heavy or electric
shock as this will adversely
affect it’s performance.
Unit is not shock proof.
Wipe the tip and probe with
a cotton swab moistened
with rubbing alcohol, or use
an alcohol wipe, before and
after each use. Then wait
at least 2 minutes to allow
the unit to readjust to room
temperature before taking
another measurement.
If necessary, use only a
soft cloth to clean the body
of the thermometer. Avoid
using thinner, benzene or
other harsh cleaners.
Do not use an abrasive
cleanser and NEVER
submerge the thermometer
in water or any other liquid.
Remove the batteries if the
thermometer will not be
used for a long period of
time.
Do not expose the unit to
extreme temperatures (cold
or hot), high humidity or
direct sunlight. Thermometer
should be stored at normal
room temperature.
Message
Instruction
Replace with 2 new
“AAA” batteries
immediately.
The temperature
measured was higher
than the specified mea-
suring range. Wait 2
minutes and try again.
Summary of Contents for KD-2220
Page 13: ......
