8
9
2.1 Fingerprint enrollment
This lock is pre-set in the Master Finger (Administer) mode. This means that
Master Finger is required to verify for all the enrollment/deletion of the
fingerprints/User Access Codes (PIN Codes) and change of data/setting. You
can change the setting to User Finger mode where you do not need Master
Finger to verify for all the enrolment/deletion of the fingerprints/User Access
Codes (PIN Codes) and change of data/setting. (Please refer to 2.4.1
Master/User Finger Mode)
7. Master Finger Mode
- This lock is pre-set in “Master Finger” mode and you are required to verify
Master finger or sub-master fingers first in all programming processes
- You can change to “User Finger” mode if you prefer simple programming
processes which do not require Master finger (or sub-master finger) verification
Correct Fingerprint Placement
Recommendation on Finger for enrollment and verification
1. Moist fingers give better images than dry fingers. If you have difficulty in
enrolling or verifying your fingerprint, try to moisten your finger with your
breath or a moisture
2. Dirty fingers are not recommended to apply not only generating obscure
fingerprint image,but also possible scratching the glass of the fingerprint
sensor. Make your finger clean before use
3. Pointer fingers are recommended to use when enrolling fingerprint. They are
the easiest and most convenient fingers to use in programming and
verification process.
2.1.1 How to enroll master finger (ID number : 00)
This is the first fingerprint enrollment after successful installation of the lock on the door.
Step 1
: Open battery cover and press the “F” button in the back body
Step 2
: Pull up the sliding cover in the front body of the lock within 10 seconds
upon the completion of Step 1. You should see the fingerprint sensor
light up in red
Step 3
: As soon as the sensor light comes on (in red, as explained in the Step
2), place the finger of your choice - flat, firmly against the surface of the
sensor (scanning platform). When the sensor light turns off, remove
your finger and then promptly put it back on the scanning platform
again. The sensor will light up in red the second time and then turn
itself off following the second scan of that same finger. You will hear a
triple beep sound indicating the success of this fingerprint enrollment
and then see the LED display “id”
ID number “00” will be assigned automatically for master finger
Master fingerprint will remain undeleted until deletion of all fingerprints
or factory reset mode is made.
Step 4
: If you want to register other finger, then put your preferred “ID” number
(01 ~999) and press “#”. (or just press “#” without entering ID number)
and the fingerprint sensor will turn on for the new fingerprint enrollment
continuously.