Cutler-Hammer EATON PanelMate ControlNet, Manual

Page: 18 / 43

3-2
PanelMate ControlNet Communication Driver Manual
Supported Messaging
The Operator Station with the ControlNet Interface Module supports PCCC and CIP unscheduled
messaging.
Note: PanelMate does not support scheduled messaging.
Network Connection
The figure below shows the rear of a PanelMate Power Pro Series unit. To connect the operator station
to the ControlNet network:
1. Install a "passive Tee” (Tee and drop cable are combined,) connector [1] on the network cable [2].
2. Run a drop cable [3] from the Tee connector to the BNC connector [4] on the ControlNet Module
[5].
Network Termination
If the Operator Station is the last node (at the end of) the network, install a 75
Ω
terminating resistor in
the unused plug of the Tee connector.